There are three main sections zoomed in the picture; the Headstock, the Neck, and the Body. The headstock holds the Tuner Posts around which the strings are wrapped and terminated. The Tuners are knobs that increase or decrease the tension on the string wrapped around the tuner posts (tuning the sound made by the strings). Note that some acustic guitars may have different looking tuners, and some may even have all six tuner keys on the same side. Even though they may look different, they work in the same manner. The Nut guides the strings to the tuner posts and maintains the height of the strings.

The length of the Neck depends on the scale of the guitar and the number of frets it has. The back of the neck could be "C" shaped, or "V" shaped (sideways < if you compare it to the letter C). The front of the neck is the Fingerboard or Fretboard, that (or this, or whatever) contains the Frets embedded in notches along its surface. The Strings run down the neck over the frets. The height of the strings over the frets is called the Action; if the action is too high the strings are harder to press down, if the action is too low the strings may rattle against the frets muffling the notes. The neck usually has "dot" markers on the top and the side facing the player, showing the position of the 3rd, 5th, 7th, 9th, 12th (which has two dots) and 15th fret.
(continued to right top)

Advanced Guitar Techniques
The guitar is a versatile musical instrument that allows musical creativity to be expressed very well. Picking notes and strumming chords is great for learning, but it starts to sound mechanical. Here are a few advanced guitar techniques and tricks to make your music more vibrant. As you learn, you will notice that your favorite guitarist uses these very same techniques! Click to view the Basic Guitar Lessons if needed.

The Bend is by far the most used guitar trick in the book. As this picture shows, the trick is to push the string with your fingers while fretting it (bending the string). Usually you bend strings with your ring finger, using your middle and index fingers to help. The string tension increases, changing the sound of the note. If you pick the note and then bend the string, you get the classic wail of the Blues guitar. (continued below)

(continued from left bottom)
A very common technique to break up a monotonous stretch of music is the Vibrato. At any point where a note is held (usually for more than one beat, though it works on single beats as well) - instead of leaving your finger on the fret to hold the note, rapidly wiggle the finger (up and down, or side to side). This adds a wavering quality to the note and gives it some feeling. There are many ways to add vibrato, in fact it gives many guitarists their "trademark" sound. BB King for example, does what is called the "Butterfly vibrato" where he extends the other (unused) fingers and wiggles his entire wrist.

Palm Muting is another way to get distinctive sounds out of your guitar. Although it works best on an electric guitar with distortion effects - it can also be used on acoustic guitars. Simply allow the palm of your right hand to touch the strings while you are strumming or picking the strings - this creates a flat sound or thump (depending on your gear). On some acoustic guitars that have excessive bass (the fat E string sounds too loud), you can partially palm mute by only touching the high E string - this will reduce the bass effect when you are strumming chords.

Guitars are normally tuned to E-B-G-D-A-E notes - however you can also use Alternate Tuning. This changes the open notes for one (or more) strings, completely changing the sound and of course the way you play notes. One popular alternate tuning is the Drop D tuning, where the high E string (fattest E string) is tuned down to D instead of E. Some rock and blues songs use alternate tuning - if you are trying to play one of those songs from tab or sheet music, it would be almost impossible to do so without changing the tuning of your guitar. (continued below)

Guitar tab notation is shown here, bends are indicated with an upward arrow (and may also state how much to bend FULL, 1/2 etc). Pushing the string up a little (half bend) will change the sound by one fret (half step), pushing it more (full bend) will raise the pitch by two frets (one step), and once your fingers are stronger - pushing the string all the way will raise the pitch by three frets (one and one-half step). Be warned however, bending strings can be PAINFUL at first, so practice lightly till your fingertips get de-sensitized.

The Hammer On is another popular trick. When a note is following a previous note by one or more frets, instead of picking the second note - slam your finger down on the next required fret (while holding the previous note). This changes the note to the fret you have hammered on, and gives a forceful tone to the change. The complementary technique to this is the Pull Off, which works in reverse. When you have a note that precedes a previous note by one or more frets, fret the second note while keeping your previous finger down (don't pick the string) - then forcefully "pull" back the previous finger. The trick is to remove the finger rapidly so it doesn't muffle the string vibration - the result is a forceful note change to the next note. In guitar tab, hammer on and pull offs are marked with an arc linking the frets - if its going to a higher numbered fret then its a hammer on, if its going to lower numbered fret its a pull off. A combination of both the hammer on and pull off is called the Trill - where you rapidly hammer on and pull off on the same fret several times (keeping the first finger in place throughout). This creates an undulating sound that combines both the notes.
(continued to right top)